Show interface 10Gig



  • Dears,

    when I issued show interface (10Gig), i found the input rate doesn’t exceed 9.4Gig however the port is operational in LAN-PHY mode, which as per Juniper it should support up to 10.3G

    ueser@Host# run show interfaces xe-1/0/0
    Jan 13 01:57:28
    Physical interface: xe-1/0/0, Enabled, Physical link is Up
      Interface index: 149, SNMP ifIndex: 566
      Description: #### ####
      Link-level type: Ethernet, MTU: 9192, LAN-PHY mode, Speed: 10Gbps, BPDU Error: None, Loopback: None, Source filtering: Disabled,
      Flow control: Enabled
      Device flags  : Present Running
      Interface flags: SNMP-Traps Internal: 0x4000
      Link flags    : None
      CoS queues    : 8 supported, 8 maximum usable queues
      Current address: cc:e1:7f:01:c9:4a, Hardware address: cc:e1:7f:01:c9:4a
      Last flapped  : 2015-08-17 14:38:18 EET (21w1d 11:19 ago)
      Input rate    : 9448018152 bps (1306731 pps)
      Output rate    : 1441701664 bps (905795 pps)
      Active alarms  : None
      Active defects : None
      PCS statistics                      Seconds
        Bit errors                            0
        Errored blocks                        0
      Interface transmit statistics: Disabled

    any recommendations


 

26
Online

38.4k
Users

12.7k
Topics

44.5k
Posts