Change duplex settings on SSG140 ScreenOs6.3



  • Hi All,

    for a provider change I have to change the duplex settings to fixed speed.

    I tried to do this using:

    set interface ethernet0/3 phy full 100mb
    

    I didn’t get any error message for this command, but I can’t see any changes:

    BEFORE:
    SSG140-> get int eth0/3
    Interface ethernet0/3:
      description ethernet0/3
      number 7, if_info 5656, if_index 0, mode route
      link up, phy-link up/full-duplex, admin status up
      status change:29, last change:11/09/2016 11:43:59

    SSG140-> set interface ethernet0/3 phy full 100mb

    AFTER:
    SSG140-> get int eth0/3
    Interface ethernet0/3:
      description ethernet0/3
      number 7, if_info 5656, if_index 0, mode route
      link up, phy-link up/full-duplex, admin status up
      status change:31, last change:11/09/2016 14:30:19

    When I take a look into the “Current System Configuration” in the webUI I can see the following line:

    set interface ethernet0/3 phy full 100mb

    That’s wired. Can anyone explain and/or help?

    Thank you in advance! And sorry for my bad english, but I am from Germany 🙂

    Cheers / Regards
    Borstel


 

27
Online

38.4k
Users

12.7k
Topics

44.5k
Posts